CCNA 3 Scaling Networks Chapter 7 v5.0 Exam

Refer to the exhibit. Which command should be used to configure EIGRP to only advertise the network that is attached to the gigabit Ethernet 0/1 interface?

What is the purpose of using protocol-dependent modules in EIGRP?

Which statement describes a characteristic of the delivery of EIGRP update packets?

A new network administrator has been asked to verify the metrics that are used by EIGRP on a Cisco device. Which two EIGRP metrics are measured by using static values on a Cisco device? (Choose two.)

Which protocol is used by EIGRP to send hello packets?

Which destination MAC address is used when a multicast EIGRP packet is encapsulated into an Ethernet frame?

Refer to the exhibit. R2 has two possible paths to the 192.168.10.4 network. What would make the alternate route meet the feasibility condition?

Refer to the exhibit. Which two networks contain feasible successors? (Choose two.)

If all router Ethernet interfaces in an EIGRP network are configured with the default EIGRP timers, how long will a router wait by default to receive an EIGRP packet from its neighbor before declaring the neighbor unreachable?

Which command or commands must be entered on a serial interface of a Cisco router to restore the bandwidth to the default value of that specific router interface?

Which EIGRP route would have the preferred administrative distance?

How do EIGRP routers establish and maintain neighbor relationships?

When an EIGRP-enabled router uses a password to accept routes from other EIGRP-enabled routers, which mechanism is used?

What is indicated when an EIGRP route is in the passive state?

Which three metric weights are set to zero by default when costs in EIGRP are being calculated? (Choose three.)

Why would a network administrator use a wildcard mask in the network command when configuring a router to use EIGRP?

Which table is used by EIGRP to store all routes that are learned from EIGRP neighbors?

Where are EIGRP successor routes stored?

Launch PT – Hide and Save PT
Open the PT Activity. Perform the tasks in the activity instructions and then answer the question.

Which code is displayed on the web server?

Which command is used to display the bandwidth of an interface on an EIGRP-enabled router?

Fill in the blank.